TMR Zoo Message Board

Does this work? I am planning on recessing the font area down like on a yammy headstock. 


A bit like this

I don't see any reason why it would not work ?

Looks cool to me

I have one of those Yamahas. It's a great axe.

Will look fine with that headstock. Dooo eet!!!

ok i drew up the template last night so if i get time i will do it today.

I was also wondering what you guys think of the logo/font/redline

The font is fine. It doesn't need the redline, but it isn't hurt by it. Are you gonna airbrush that fade to black near the tip, or howthef@...?

(08-07-2015, 07:15 PM)Dr. Vegetable Wrote: [ -> ]The font is fine.  It doesn't need the redline, but it isn't hurt by it.  Are you gonna airbrush that fade to black near the tip, or howthef@...?

No i was either going to print it on some veneer maple through my inkjet printer or if that doesn't work fabric. :toast:  The red was to match up with the side dots and 12th fret dots. Plus the rose alder body.

I just ordered some jumbo evo fretwire for it too. So its going to be red and gold/brass all over.



Its looking much better since that photo btw. I am quietly excited about it.

We are cautiously optimistic.

I just did it, i went a bit deep but the logo will bring it up again.

The thread title is a mess.

Quote:Would this work?

It should be

Quote: This Wood Work ?

:old: