+- TMR Zoo Message Board (http://www.tmrzoo.com/boards)
+-- Forum: The Zoo Zones (http://www.tmrzoo.com/boards/forumdisplay.php?fid=31)
+--- Forum: Guitar Gear - Amps, Axes and Effects (http://www.tmrzoo.com/boards/forumdisplay.php?fid=47)
+--- Thread: Lend me your knowledge of wiring diagrams. (/showthread.php?tid=8316)
Pages:
1
2
Lend me your knowledge of wiring diagrams. - youngthrasher9 - 05-20-2015
I opened up the Mushok to find that it has a circuit that I am not familiar with. I see 2 caps (one tiny ass orange one and a bigger standard .022uf), and 2 resistor looking things on the push pull.
I can't find a diagram that looks similar.
My guess is that it has some sort of treble bleed mod.
![[Image: BCE1E774-A208-4633-9811-F07419D1F706_zps7pao1cwx.jpg]](http://s288.photobucket.com/user/younthrasher9/media/Mobile%20Uploads/BCE1E774-A208-4633-9811-F07419D1F706_zps7pao1cwx.jpg.html)
RE: Lend me your knowledge of wiring diagrams. - youngthrasher9 - 05-20-2015
I don't really want a bleed.
If I can find a way to wire some pickups up without completely rewiring it that would be tits.
RE: Lend me your knowledge of wiring diagrams. - Agileguy - 05-20-2015
Yeah, that's a treble bleed.
What's connected to the switch? I can't quite tell.
I can tell you where to solder the wires if you give me a mo to check my Mushok.
RE: Lend me your knowledge of wiring diagrams. - Big Flannel - 05-20-2015
Remember that dimarzio wiring codes are different too.
RE: Lend me your knowledge of wiring diagrams. - lreese - 05-20-2015
I'm going to take a guess -
Its a partial split/capacitor setup. Meant to improve on the split hum bucker sound.
RE: Lend me your knowledge of wiring diagrams. - youngthrasher9 - 05-20-2015
A black ground jumper from the back of the volume pot to the switch and red sleeved pair that has one white second sleeved connect to the lowest pin on the volume pot and bare to the ground spot to the switch.
Super hard for me to put into words, sorry.
RE: Lend me your knowledge of wiring diagrams. - youngthrasher9 - 05-20-2015
(05-20-2015, 06:10 PM)lreese Wrote: I'm going to take a guess -Define "improve".
Its a partial split/capacitor setup. Meant to improve on the split hum bucker sound.
RE: Lend me your knowledge of wiring diagrams. - lreese - 05-20-2015
RE: Lend me your knowledge of wiring diagrams. - youngthrasher9 - 05-20-2015
That's dimarzio coded, right?
RE: Lend me your knowledge of wiring diagrams. - lreese - 05-20-2015
No but looks fairly simple...
The wires that are twisted and soldered together to make a series connection go to the push/pull instead of the white wire. 2.2K side for the bridge and 1.1K for the neck. You might need to adjust those resistor values for hotter pickups.