+- TMR Zoo Message Board (http://www.tmrzoo.com/boards)
+-- Forum: The Zoo Zones (http://www.tmrzoo.com/boards/forumdisplay.php?fid=31)
+--- Forum: Guitar Gear - Amps, Axes and Effects (http://www.tmrzoo.com/boards/forumdisplay.php?fid=47)
+--- Thread: Hey, Kinni (/showthread.php?tid=8396)
Hey, Kinni - Dr. Vegetable - 05-30-2015
Your guitar body carving jobs are awesome. I was thinking about possibly maiming one of my guitars with some custom body art. Surfing the www, I found this nifty little toy. (You'll shoot yer eye out, kid!)
http://www.robotshop.com/en/laser-engraver-xy-plotter-robot-kit-v20.html
What do you think? Would it be feasible to etch a design into a guitar using a digital laser cutter?
RE: Hey, Kinni - kinnikuman - 05-30-2015
I dont know bro i haven't had anything to do with those, But i imagine it would be shitty wok.
I guess it depends on the job too but Dremel/chisels is the go. I will investigate them today and come back with more knowledge.
If you let me know what ideas you have i can tell you what way i would go about doing it.
RE: Hey, Kinni - kinnikuman - 05-30-2015
Fuck it would be awesome for inlays.
https://www.youtube.com/watch?v=XA5X6-vornk
RE: Hey, Kinni - Dr. Vegetable - 06-03-2015
I have the laser engraver kit coming on the slow boat from China (literally), so I'll let you know when I've built it and run a few pieces of scrap wood and/or MIC ESPs through it. Should be fun to smell the burning poly.