01-31-2015, 08:05 PM
(This post was last modified: 01-31-2015, 08:07 PM by kinnikuman.)
(01-31-2015, 07:59 PM)Oinkus Wrote: I took a planer to my Futura it doesn't look anything near that good. It is a great idea and not really that hard if you have the tools.
How would you get a planer in there? Do you mean like an orbital sander? I think if i do i would just make a template out of plywood then just run a top bearing router bit around.
I will just have to see what i think once i get the wings on. The truss rod i used in this is just a warmoth one which falls a bit short of the end of the fretboard. So i dont really want to make the neck heel thin after the truss rod. If that makes sense.