04-13-2016, 10:49 AM
Yes it would if you care to measure.
Looks like I'm SOL on the pine. Not one lumber store in town has anything over 12" wide. I need at least 14" minimum. To special order 16" void free is about 3 times the price as 12". I can buy an unloaded 2x12 on fleabay for what the lumber alone would cost.
I need a new material. The only birch I can find in town is 7 ply. It would work, but that stuff will have little voids all in the inner plys. The 11 ply has much less.
I did find some nice Aspen wood, multi piece planks that are 15". They are pieced and glued together like a hard wood floor. Each smaller piece is about 2"x5". Very uniform and Void free. I can even get pieces wide enough for the baffle and rear panel. I'll have to do some research, but that might work.
I did get the speakers today. The temptation to mix one with a Swamp Thang, in one of my 1x12 cabs is brutal. I may just have to try that out until I get this 2x12 done.
Looks like I'm SOL on the pine. Not one lumber store in town has anything over 12" wide. I need at least 14" minimum. To special order 16" void free is about 3 times the price as 12". I can buy an unloaded 2x12 on fleabay for what the lumber alone would cost.
I need a new material. The only birch I can find in town is 7 ply. It would work, but that stuff will have little voids all in the inner plys. The 11 ply has much less.
I did find some nice Aspen wood, multi piece planks that are 15". They are pieced and glued together like a hard wood floor. Each smaller piece is about 2"x5". Very uniform and Void free. I can even get pieces wide enough for the baffle and rear panel. I'll have to do some research, but that might work.
I did get the speakers today. The temptation to mix one with a Swamp Thang, in one of my 1x12 cabs is brutal. I may just have to try that out until I get this 2x12 done.
I hear Mexico is nice this time of year.