05-20-2016, 01:02 PM
The tone stacks in the middle of the preamp gain stages are interesting. With all the tube sockets already there, a 2203 preamp is nothing to wire in with that setup.
The power section really is close isn't it? That setup on the PI is almost identical. You can already see how its layed out on your terminals too. Would only take a few minutes to change all that over.
I need to look at, The Pigs, schematic too. It can't be that much to run kt88's. Probably just a few resistor changes, and a cap or two.
Does having different primary voltages than me change the values in the amp, or do the transformers give you the same secondaries I get?
The power section really is close isn't it? That setup on the PI is almost identical. You can already see how its layed out on your terminals too. Would only take a few minutes to change all that over.
I need to look at, The Pigs, schematic too. It can't be that much to run kt88's. Probably just a few resistor changes, and a cap or two.
Does having different primary voltages than me change the values in the amp, or do the transformers give you the same secondaries I get?
I hear Mexico is nice this time of year.