05-29-2016, 09:16 PM
I haven't done any measurements yet but I noted The plate voltage [ HT1] in this is rated at 648v whereas your windsor is rated at 462v. There are some differences. I'm going to go over the circuits plus the KK mod because I'm figuring the P.T. has plenty to drive a quad of KT88's. I'm thinking if I do a P.S. clean up [ new caps etc ] and it produces the results of eliminated noise, I'll go the whole hog and do the KK mod to run the KT's.
I was trying to do this last night but after a couple of days of wood collecting and cutting etc I was a bit tired and the eyes kept blurring out. I hope to get back to it today plus bit of voltage level measurement.
My Vase runs a pair of 88's and I have two sets. One NOS Gold Lion GEC's and the other is a Gold Lion reissues.
They sound pretty good compared to the GEC's. I'd grab another pair if I did this.
- http://www.ozvalveamps.org/eminar/eminar...uit-sb.png
I was trying to do this last night but after a couple of days of wood collecting and cutting etc I was a bit tired and the eyes kept blurring out. I hope to get back to it today plus bit of voltage level measurement.
My Vase runs a pair of 88's and I have two sets. One NOS Gold Lion GEC's and the other is a Gold Lion reissues.
They sound pretty good compared to the GEC's. I'd grab another pair if I did this.
- http://www.ozvalveamps.org/eminar/eminar...uit-sb.png

