06-06-2016, 12:04 AM
(This post was last modified: 06-06-2016, 12:10 AM by GoldenVulture.)
FMD I got the caps today. I should've payed closer attention to the item description.
The pic they had was wrong. It is for a 250uf cap [69mm x 35mm] with eyelet terminals.
![[Image: 250-500jj3.jpg]](http://www.evatco.com.au/wp-content/uploads/2013/11/250-500jj3.jpg)
I presumed a wrong picture but the item would be the same/similar dimensions etc.
What I got was PCB mount caps [43mm x 20mm ] about 1/3 the size of the pictured type with
PCB mount terminals. The dimensions were in the item description but I didn't pay attention to it.
I got deceived by the pic. They look like this.
![[Image: 47-835.jpg]](http://www.evatco.com.au/wp-content/uploads/2013/11/47-835.jpg)
[ almost exact size ]
I'll try them out but I don't think they're going to be able to deliver the power they should.
I also ordered some resistors. They came as odered in lots of ten Except for one . They were three short.
On the invoice there is a note they will send them when they restock.
[ $1 for each ten pack]
I'm back to finding some decent cans now.
The pic they had was wrong. It is for a 250uf cap [69mm x 35mm] with eyelet terminals.
I presumed a wrong picture but the item would be the same/similar dimensions etc.
What I got was PCB mount caps [43mm x 20mm ] about 1/3 the size of the pictured type with
PCB mount terminals. The dimensions were in the item description but I didn't pay attention to it.
I got deceived by the pic. They look like this.
[ almost exact size ]I'll try them out but I don't think they're going to be able to deliver the power they should.
I also ordered some resistors. They came as odered in lots of ten Except for one . They were three short.
On the invoice there is a note they will send them when they restock.
[ $1 for each ten pack]I'm back to finding some decent cans now.