06-04-2016, 04:54 AM
I have this idea sussed out for a single piece body.
1. Route out the humbucker cavity as normal
2. Use this bit to take away the inside cavity walls on both sides closest to the knob but leaving the top. http://www.ebay.com.au/itm/Router-Bit-Sl...SwDuJWxX4K
3. This is where it gets tricky. I Get this bit into the cavity, Because i used that bit earlier ^^ i can now get it in and have enough room to start the router. http://www.ebay.com.au/itm/371436748275?...EBIDX%3AIT
If i used a mini pot i would have about 8mm distance from the edge of a strat knob to the humbucker ring.
1. Route out the humbucker cavity as normal
2. Use this bit to take away the inside cavity walls on both sides closest to the knob but leaving the top. http://www.ebay.com.au/itm/Router-Bit-Sl...SwDuJWxX4K
3. This is where it gets tricky. I Get this bit into the cavity, Because i used that bit earlier ^^ i can now get it in and have enough room to start the router. http://www.ebay.com.au/itm/371436748275?...EBIDX%3AIT
If i used a mini pot i would have about 8mm distance from the edge of a strat knob to the humbucker ring.