03-07-2015, 04:51 AM
(03-06-2015, 06:22 PM)Oinkus Wrote: I just had some issues with bridge screws and the spring on a Nashville was a pain. Only problem is you have to make sure the file doesn't move at all and make sure you turn down the drill press for only a few rotations at a time slow is good. I have grown to hate wraparounds , last few I have gotten have been just awful to work on. Plug , drill and install a TOM or anything else.
good points bro.
I am only using this bridge because someone had done a failed fr conversion on this and fucked it. So i wanted to restore it but i needed a bridge that would be wide enough that the posts go into the actual body wood and not the plug.